Designed Right, Built Right

Comprehensive Product Line

• 7.5 HP through 75 HP, open drip-proof enclosures
• 1200 RPM and 900 RPM, high acceleration torque, low current draw, Elevator Duty designs
• 200, 230/460 and 575 Volt ratings. 60, 40 and 30 Hertz designs
• More efficient, lower current, 30 and 40 Hertz designs can result in reduced drive size
• Normally closed thermostats, one per phase

Tough Standards

• Dynamic Balanced per NEMA to assure smooth, vibration free car operation
• Ground tested at the winding stage, surge and ground tested before final assembly then given a commercial test per NEMA

Increased Motor Life

Our Enhanced Class F Insulation System handles the wave front voltages and dvdt levels that are major factors affecting elevator motor insulation life. Phase insulation, slot liners and wedges are high dielectric strength materials. A two component, 100% reactive, solventless polyester resin Class H varnish is used to impregnate the hoist motor stators. This varnish provides superior protection and strength as well as being in compliance with industrial environmental regulations. Lincoln’s insulation system exceeds the requirements for inverter-fed motors per NEMA MG1, Part 31.

Superior Construction

Our rigid, low noise, low vibration construction features include rugged steel frame construction with cast iron end brackets and heavy cast steel, full length feet with gussets, welded to each side of the frame. Our hoist motors are provided with elevator shaft end play and oversized ball bearings with two pre-loading bearing washers to insure quiet bearing operation and centering of the rotor. A standard one inch diameter stub shaft for encoder mounting is machined as an integral part of the AISI 1045 hot rolled, medium carbon steel shaft (not a press in or bolt on piece that may require alignment).

Hydaulic Elevator Pump Motors

Two Motors In One

Introducing Dual Rated Nameplates

for both 80 starts per hour

and 120 starts per hour

Dual Rating Nameplates

•  80 and 120 starts per hour dual rating nameplates

• Designed for belt driven pumps

• Foot mounted, open drip-proof

• 10 HP – 100 HP, 1800 RPM

• Wye Start/Delta Run or start and run on Delta

• Three phase, 60 Hertz

• 200, 230/460 and 575 Volts

• Enhanced Class F insulation

• Rigid construction for low noise and low vibration

• NEMA dimensions

We Build Little Ones Too!

(with features like their big brothers)

• 5, 7.5 and 10 HP, 1800 RPM

• 80 starts per hour

• Wye Wound for electronic start or across the line starting

• Three phase, 60 Hertz

• 200, 230/460 and 575 volts